High Performance Concrete

Materiali metalco web-03

HIGH PERFORMANCE CONCRETE

Mixture of reinforced performing concrete, with granite or marble aggregates, with a good technical and structural performance. Aggregates are accurately selected and offered in different versions (granite, white marble or black marble).

Key features of HPC products

Possible surface finishes of HPC products are:

VELLUTO SURFACE AND SIDES
POLISHED SURFACE AND VELLUTO SIDES

Finishing are not available on all products: in order to check the finishing available on each product, please see the section dedicated to each product. Surfaces are treated with specific products anti-degradation, which increase products’ life and resistance characteristics to rain erosion and to mold and similar events.

Upon request, with extra-charge, it is possible to request “ANTIGRAFFITI”treatment or, alternatively, WAX TREATMENT.

Generally HPC products come with bushings embedded in the stone for lifting them during the installation phase.

hpc-gran-velluto-500x350

HPC with granite
VELLUTO

hpc-granito-500x350

HPC with granite
polished

hpc-nero-velluto-500x350

HPC with black marble
VELLUTO

hpc-marmo-nero-500x350

HPC with black marble
polished

hpc-bianco-velluto-500x350

HPC with white marble
VELLUTO

hpc-marmo-bianco-500x350

HPC with white marble
polished

N.B.: The images reproduced in these pages are merely indicative; please refer to physical samples.

Finishes

DIAMANTE F
HPC-diamante F
DIAMANTE – AGATA – NATURAL PUZZLE – ISOLAURBANA
HPC2

Maintenance.

Wash the material with water and mild detergent, to avoid dirt and weathering deterioration. It is possible to repair small chips with specific kits to be ordered according to the type of product.
In case of any doubt about the proper maintenance procedure, please contact the Metalco Quality Department for advice.

General requirements applicable to all Metalco’s products in any material

Upon receipt of the goods, where it is not possible to place and/or install them within a few days, they must always be removed from plastic (nylon) packaging to allow ventilation and prevent the formation of condensation that can irreparably damage the product. Particularly, the packaging should always be removed immediately if it is not possible to keep the goods in a covered place protected from sunlight.